I very recently became paralyzed in my left (and dominant) arm, fingers and foot, which believe it or not, was not planned for.
The timing was pretty bad, as I’ve just purchased a couple of ESP3266-boards, a soldering kit and two pressure mats with the the end goal of making a basic bad sensor (one mat for my girlfriend and my side). (Here’s the guide I intend to follow: Make your own bed sensor)
The obvious issue is how one, as easily as possible, can accomplish this? Main issues right now are that I can’t hold the board, the wires or anything in my hand.
Any and all tips are greatly appreciated.
Am blind, can solder (badly). Afraid I can’t help but best of luck.
https://lemmy.world/post/45525365
How the hell? I hope that’s not offensive. But that’s incredible.
Blind != No Sight. It’s possible they have low vision. They do mention an assistive magnifier in a comment on that post. Still more challenging than a fully-sighted individual, and would take a lot of practice. All too often though people assume blind means no sight at all.
This is correct.
Yes, that’s what I assumed, thanks for clarifying.