You must log in or register to comment.
What you have there is a hard disk drive. In order to fit it into the CD drive (or Compact Disk drive) you need to first compact it! A hydraulic press is the preferred method.
Too big, use this:
You have to sand it down to fit. Easy mistake to make
You have to use toothpaste (if I remember correctly).
You goof, you need to put it into the floopy drive!
That’s a drinks coaster.
Because they are prefab ninja stars.
They make really good spin fidgets.
Yup. Really nice bearings. I also have a few HDD magnets that work well as hold-downs for laser cutting.
Putting it in the freezer might shrink it down a bit.
Put it back into its CD drive, the one on the table that you took apart for no reason at all, and it’ll work a treat, I promise.
